NEC N8800-103F User Manual page 78

4-30 Windows Setup
IMPORTANT:
To perform this procedure, you need to log on as an administrator or a
member of administrator group.
RDR can only be set on the basic disk inserted into the built-in slot of
NEC Express5800/ft series. It cannot be set on the dynamic disk.
For the disk on which RDR is set, use the products with the same serial
number.
Be sure to configure the RDR settings in the same way not only when
the OS is installed but also when the disk is added to the PCI module.
Follow the steps below to configure the dual disk configuration.
Click [Start] – [All Programs] – [RDR] – [RDR Utility], to start the RDR Utility.
1.
IMPORTANT:
If the disk status of the disk (Slot 1 of the PCI module 0) on which the system is installed
is "Boot, configured Active or Imported," performing the steps 2 to 4 are not required.
Go to step 5. If the disk status is other than "Boot, configured, Active or Imported," go
on to step 2. To check the "disk status," click the disk on which the system is installed
from the left pane of RDR Utility and check the "disk status" display on the right pane.
TIPS:
- For the details on RDR Utility, see "Disk Operations Using the RDR (Rapid Disk
Resync) Function" in "Disk Operations" in Chapter 3, "Windows Setup and
Operation." in the User`s Guide.
- The RDR Utility display is not updated automatically. Each time you perform
disk-related operations such as inserting or removing a disk or RDR setting, click
[Action] from the menu and click [Refresh] (or press the F5 key) to update the
display.
- In RDR Utility, PCI module names correspond as follows:
- PCI module (for CPU/IO module 0) - PCI module 0
- PCI module (for CPU/IO module 1) - PCI module 1