NEC N8800-103F User Manual page 80

4-32 Windows Setup
Insert the disk to set dual configuration into the corresponding slot. (In this case Slot 1 of
5.
PCI module 1).
IMPORTANT:
When a disk is inserted a popup window for asking to reboot the computer may be
displayed, but you do not need to reboot it. Click [No] and close the popup
window.
As for the disk to be inserted, use a new disk or a physically formatted disk with
the same capacity as the synchronization source disk. If you use other disks, dual
configuration is not set normally.
As for physical format, refer to "SAS BIOS ~ Adaptec SAS/SATA~ Configuration
*
Utility" in Chapter 4, "System Configuration" in the separate volume of the User's
Guide, and perform Format Disk with Disk Utilities
To perform "Low-Level Format," on the BIOS setup utility, click [Server],
[Monitoring Configuration] and set [Option ROM Scan Monitoring] to [Disabled].
For how to configure the settings, see "System BIOS ~ SETUP ~" in Chapter 4,
"System Configuration" in the separate volume of the User's Guide.
Right-click the Slot 1 of the PCI module 1 from the left pane of RDR Utility, and then click
6.
[Add Physical Disk To RDR Virtual Disk].
Click [OK].
7.