NEC N8800-103F User Manual page 90

4-42 Windows Setup
Enter the location, where debug information is to be written, in the text box.
4.
When writing debug information under the file name "MEMORY.DMP" in the D drive:
D:\MEMORY.DMP
IMPORTANT:
[Complete memory dump] should be specified for writing debug information.
However, if the mounted memory size is over 2GB, specify [Kernel Memory
Dump]; you cannot specify [Complete memory dump] ([Complete memory dump]
is not displayed on the menu).
Specify a drive which has a free space of the size of memory in the NEC
Express5800/ft series + 12MB or more (If the memory size is over 2GB, 2048MB
+ 12MB).
If the memory will be expanded to larger than 2 GB, change Write Debugging
Information to [Kernel Memory Dump] before expanding the memory. Size of the
debugging information (memory dump) to be collected will change due to memory
increase. Check how much free space the hard disk to which debugging
information is written has.
If an error such as a stop error of the OS occurs, the normal dump function may
run instead of the quick dump function depending on the system status. However,
the memory dump file can be used for failure analysis equivalent to that of the
quick dump function
In the system failure settings, it is recommended to specify "Automatically
restart." When this option is not selected, the system cannot be restarted after the
operation is switched to the disks that are mirrored when the system cannot be
started due to a disk error.