NEC N8800-103F User Manual page 129

Windows can be operated after a setup but each module or PCI board is not duplicated. (Status
LED 2 on the CPU/IO module does not light on green).
Did you abort the installation during a setup such as by closing a window of the programs that
are running?
→
Installation will be aborted if you finish the programs that are running such as by closing
a window. Although the operation on Windows will be feasible, PCI boards will not be
duplicated properly if you abort the installation. In this case, "Step 1: Things Required
for Setup" needs to be done from the beginning.
DISK Access LED will be lit in amber.
Did you properly setup the duplex of HDDs?
→
DISK Access LED will be lit in amber, if a setup for duplex is not performed. (See
"LEDs" in the separate volume of the User's Guide for details about the indication status
of LED.) See "Step 8: Set Dual Disk Configuration" in Chapter 4 and set up the duplex
of HDDs.
"Complete memory dump" cannot be specified to the write debug information on "Set Memory
Dump" (Debug Information).
→
"Complete memory dump" cannot be specified (not displayed) if the memory size
exceeds 2GB. Specify "Kernel memory dump" in this case.
Cannot find the recommended value for a paging file.
→
See "Size of the Partition to be Created" in "Step 1: Things Required for Setup."
Cannot specify a network path for the storage location of diagnosis information (collect log) in
"Set Dr. Watson."
→
You cannot specify a net
The Telnet Serv ice is not installed.
→
Adjust the computer name to 14 characters or less,
according to <How to install the Teln
<How t
1.
2.
3.
Note:
work path. Specify a path to a local computer.
o install the Telnet Service>
Select [Run] from the Start menu.
Type "tlntsvr /service" in the [Open] box, and click [OK].
From the Start menu, point to [Control Panel] and click [Administrative T
then click [Services] to specify whether the Telnet Service is registered.
Once the installation of Telnet S
name to 15 or more characters.
and then install the Telnet Service
et Service>.
ervice is finished, you may change the computer
Troubleshooting 6-15
ools] and