5. Bundled Software Installation Guide
5.1.
Hardware Installation
1. Connect the male connector of RS232 cable to the UPS communication
port.
2. Connect the female connector of the RS232 cable to a dedicated RS232
port of the computer.
3. For optional interface cards, you may refer to Chapter 6 for installation.
5.2.
Software Installation
Please refer to the user's manual of the software for installation.
40
6. Customer Options Slots
6.1.
All the below interface cards are with built-in EPO function.
The pin assignments of the EPO are:
1
EPO+
1
2
2
Ground
6.1.1. To enable the EPO function, please short Pin 1 & 2.
6.2.
R2E(2nd RS-232 ) card
6.2.1. CN1 is for RS232 DB9 and CN3 is for EPO.
6.2.2. For communication protocol, please
refer to Chapter 2.4.1
6.2.3. Installation Position: slot1 or slot 2.
6.2.4. Adapted flat cable: cable A or cable B
6.2.5. For installation, please refer to Chapter
6.7
6.3.
RSE(RS-485) card
6.3.1. CN1 for EPO, CN2 for RS485 and CN3
for remote power.
6.3.2. For communication protocol, please see
the definition below:
CN2
1
Ground
1
2
3
2
A/Data+
3
B/Data-
CN3
1
AC+
1
2
2
AC-
6.3.3. Installation Position: slot1 or slot 2.
6.3.4. Adapted flat cable: cable A or cable B
6.3.5. For installation, please refer to Chapter 6.7
41