Ablerex MSII-RT User Manual page 15

D
* It shows "test".
E1
* It shows "OK" in self-test
E2
* It shows "Fail" in self-test
F
* It shows "220Vac" in Utility Input.
3.5.1.8 In case of failure in self-test, the LCD display will illustrate from Drawing D
to drawing E2, then an error code or error status will be shown on the screen.
28
3.5.1.9 Your start-up operation of the UPS is completely now. Make sure the
UPS is plugged onto the wall receptacle for charging at least 8 hours and the
batteries of the UPS are fully charged.
3.5.2 Start-up in Battery Mode (Cold Start)
3.5.2.1 Make sure the UPS you have has already been installed at least 1
set(20pcs) of 12V/7AH or 12V/5AH batteries.
3.5.2.2 Push the UPS On Switch
and then the buzzer sounds twice. The LCD display will illustrate from drawing A
to drawing G, and keep awake for approx. 10 seconds.
3.5.2.3 Press the UPS On Switch
the LCD display illustrates from drawing G to drawing H, then the UPS will be in
self-test Mode. The UPS may offer energy to the output in a minute, and the LCD
display illustrates as drawing I. In case of failure in pushing the UPS On Switch in
10 seconds, the UPS will automatically turn off. You then have to go through step
0 to 0 once again.
G
* It shows "Off", which means the UPS pre-start is successful.
H
* It shows Utility input is "0" and Utility Abnormal.
I
to awake the UPS for approx. 3 seconds,
of the UPS again for about 3 seconds till
29