Table of Contents
Advertisement
monitoring program can also display any errors for fast troubleshooting.
2.2.7.
The modular design of this UPS means it can not only operate
independently but also in parallel mode for even higher power output.
2.2.8.
It has passed CE safety and electromagnetic interference protection
certification.
6
3.
Unpacking and Installation
The UPS may experience unexpected circumstances during transportation.
We recommend inspecting the packaging for any signs of damage or improper
handling before unpacking so you can contact the distributor immediately.
At least 3 people are required during unpacking and installation for safety
reasons.
3.1.
Environmental Requirements
A proper installation environment not only ensures the effective operation of
the UPS but also reduces the chance of failure and extends service life. Please
take the following recommendations into account to select the most suitable
environment and reduce the likelihood of accidents.
3.1.1.
This product must not be used in an environment with sparks, smoke or
gas to prevent arcing, injury, and fire hazards.
3.1.2.
Avoid using dusty materials, volatile gases, or corrosive substances
with a high salt-content in the environment where the UPS is installed.
3.1.3.
The installation location of the UPS should be well-ventilated. During
charging, the chemical reaction of the battery generates small amounts
of gases. If there is a crack in the battery then this may pose an
environmental hazard.
3.1.4.
Please check the installation location. Do not install the UPS in an
environment outside the range specified in the manual (Temperature:
0-40, relative humidity: 0-95%) that is too hot or too humid.
3.1.5.
Do not place in a location near a heat source as this will shorten the
battery life.
3.1.6.
Do not place outdoors and avoid direct exposure to sunlight.
3.1.7.
Please ensure that the environment where the UPS is placed is free
from animals that may damage the wiring, such as: rats and other small
animals.
3.1.8.
Please ensure that the floor is strong enough to hold the UPS and
battery. It must keep the equipment stable to ensure that it won't suffer
damage in a fall.
3.1.9.
We recommend placing a fire extinguisher near the UPS in case of an
7
Advertisement
Table of Contents
