Installation And Operation; Unpacking; Selecting Installation Position - Ablerex MSII-RT User Manual

3. Installation and Operation

The packing condition and the external outlook of the unit should be
inspected carefully before installation. Retain the packing material for future use.
3.1.

Unpacking

3.1.1. Take out the UPS Module, Battery Module or Isolation Transformer
with/without Maintenance Bypass Switch from the PE foam.
3.1.2. Unwrap the UPS Module, Battery Module or Isolation Transformer with/
Without Maintenance Bypass Switch. .
3.1.3. Standard Package of the UPS Module includes:
1 set of Quick Start Manual
1 set of User's Manual
1 set of UPS communication software with RS232 cable
1 set of accessories pack
3.1.4. Package for the Isolation Transformer with Maintenance Bypass Switch:
1 set of 12 inches long NEMA L5-30P and a 12 inches long NEMA
L5-30R
3.1.5. Package for the Isolation Transformer without Maintenance Bypass
Switch:
3pcs additional No. 10 AWG, 60°C copper wire
(p.s. 2pcs 12 inches long NEMA L5-30P and 1pcs 12 inches long NEMA L5-
30R are to be used at the input/output terminal block of the UPS. Please
refer to Chapter 0 for installation.)
12
3.2.

Selecting Installation Position

It is necessary to select a proper environment to install the unit, in order to
minimize the possibility of damage to the UPS and extend the life of the UPS.
Please follow the advice below:
1. Keep at least 30cm (12 inches) clearance from the rear panel of the UPS to
the wall.
2. Do not block the air-flow to the ventilation openings of the unit.
3. Please check the installation site to avoid overheat and excessive moisture.
4. Do not place the UPS in an environment near dust, corruptive or salty
material or flammable objects.
5. Do not expose the UPS to outdoors.
AIR
AIR
0
40
0
C
Relative Humidly
(non condensation) 30%~90%
0
C
13