Communication Software; Hardware Setup; Software Installation; Technical Specification - Ablerex ARES User Manual

ARES UPS User Manual

Hardware Setup

Connect to either RS-232 communication or USB communication.
Connect a male RS-232 connector or a USB cable* to the UPS communication port. Connect the female
RS-232 connector or the other end of the USB cable to the computer.
*Note: RS-232 cable is optional.

Software Installation

Please refer to the PowerMaster user's manual.
Model
Capacity
VA
W
Input
Voltage Rating
Frequency Rating
Phase
Power Factor
Current harmonic distortion (THDi)
Generator Input
Output
Voltage
Voltage Regulation
Frequency(Synchronized Range)
Frequency (Battery Mode)
Current Crest Ratio
Voltage Harmonic Distortion(THDv)
Output Waveform
20

COMMUNICATION SOFTWARE

TECHNICAL SPECIFICATION

230V – 1K
1000 VA
900W
110/150/180~300 VAC (Based on load percentage0 ~ 60% / 0 ~ 75% / 0 ~ 100%)
230 V, adjustable to 200/208/220/230/240
Static: within ±1% until low-battery warning
50/60 Hz ±0.2% unless synchronized to line
230V – 2K
2000 VA
1800W
44-66 Hz
50Hz fin> 44Hz and fin < 56Hz
60Hz fin> 54Hz and fin < 66Hz
≧ 0.99 at full linear load
Single phase with ground
<7% at full load and nominal voltage
Supported
3 Hz or 1 Hz (selectable)
3:1
< 3% at full linear load
< 6% at full non-linear load
Pure sine wave
230V – 3K
3000 VA
2700W