Button Functions - Kemppi FastMig MXP 37 Pipe Steel Operating Manual

3.3

Button functions

3.3.1 ON/OFF button (1)
Short press: XF 37 / X 38 panel returns to initial display.
Long press: XF 37 / X 38 panel is turned ON or OFF.
NOTE!
panel X 37 turns on and links automatically to this wire feeder.
3.3.2 Dynamics button (2)
CH REMOTE
CHANNEL
Short press: Dynamics setting for 1-MIG, synergic MIG and CC/CV. ArcForce setting for MMA.
EN
Long press: Wire feeder number selection. If there is more than one wire feeder connected to
the system, you can select which of them is active. Each wire feeder has its own number (1–3).
NOTE!
3.3.3 Gas test button (3)
CH REMOTE
CHANNEL
This button displays the gas test time. You can change it with the control knob.
Gas test starts when the time adjustment is made, after a short delay.
You can stop gas test by pressing any button.
3.3.4 Wire inch button (3)
EMOTE
ANNEL
4T
This button starts feeding the wire with the default speed of 5.0 m/min. The wire feed stops
2T
when you release the button. CH REMOTE
You can change the wire feed speed with the control knob. The changed speed is used if you
press the button again.
3.3.5 Channel down button (5)
CH REMOTE
CHANNEL
4T
This button selects the previous memory channel that can be found.
2T
3.3.6 Channel up button (6)
Short press: Selects the next memory channel that can be found.
Long press: Locks or unlocs the selected memory channel. No parameter changes are allowed
to a locked memory channel.
16
FastMig MXP 37 Pipe, MXP 38
When wire feeder XF 37 / XF 38 control panel is turned ON, also the power source control
4T
2T
Wire feeder number is not available in MMA, CC and CV processes.
4T
2T
PANEL
CHANNEL
XF 37
WISEROOT
+
PANEL
WISEROOT 4T
+
2T
XF 37
PANEL
XF 37
PANEL
XF 37
/
4T
2T
/
PANEL
XF 37
PANEL
XF 37