Loading The Filler Wire And Automatic Feed; Gt04 Wire Feed Mechanism In Mxp 37 Pipe - Kemppi FastMig MXP 37 Pipe Steel Operating Manual

2.7

Loading the filler wire and automatic feed

Automatic wire feed makes wire spool changes faster. When changing the wire spool, the
pressure of feed rolls need not be released.
Simply ensure that the groove of the feed roll matches the diameter of filler wire used. Release
the wire end from the spool and cut off any deformed section. Be careful that the wire does
not spill from the spool sides.
Straighten about 20 cm of filler wire and ensure the tip has no sharp edges. File if necessary, as
a sharp wire edge may damage the wire gun liner - particularly softer plastic liners.
Present the filler wire tip to the back of the wire feed rolls and press the wire inch switch on
the wire feeder panel. Feed the wire to the gun contact tip and prepare to weld.
Smaller diameter filler wires may need to be loaded manually and with the feed roll pressure
NOTE!
arms released. This is because it is easy to over estimate the pressure required to feed these smaller
filler wires. Too high feed roll pressures can easily deform filler wires and contribute to later feeding
problems.
2.8

GT04 wire feed mechanism in MXP 37 Pipe

Wire guide tubes
EN
Al, Ss (Fe, Mc, Fc)
plastic
Fe, Mc, Fc
metal
8
FastMig MXP 37 Pipe, MXP 38
ø mm outlet tube
0.6 W007285
0.8 – 0.9 W007286
1.0 W007287
1.2 W007288
1.4 W007289
1.6 W007290
2.0 W007291
2.4 W007292
0.8 – 0.9 W007454
1.0 W007455
1.2 W007456
1.4 – 1.6 W007458
2.0 W007459
2.4 W007460
middle tube inlet tube
W007273 W007293
W007274 W007294
W007275 W007295
W007276 W007296
W007277 W007297
W007278 W007298
W007279 W007299
W007280 W007300
W007536
W007537
W007538
W007539
W007540
W007541