Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X10DAL-i User Manual

2-5

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and the same speed.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
JPL2
JHD_AC1
BIOS
Battery
BT1
S-SATA3
S-SATA2
S-SATA1
PCH
S-SATA0
JSD2
I-SATA3
I-SATA2
I-SATA1
I-SATA0
JL1
JSTBY1
JF1
LEDPWR
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
modules to prevent any possible damage.
USB5/6 (3.0) USB3/4 (3.0)
FAN6 J21
JPI2C1
HD AUDIO
LAN2 LAN1
X10DAL-i
FAN5
Rev. 1.02
CPU2
CPU1
JPWR2
JPWR1
CAUTION
2-13
Chapter 2: Installation
Notches
Release Tabs