Installing And Removing The Memory Modules; Installing Memory Modules; Removing Memory Modules - Supermicro X10DRG-O+-CPU User Manual

2-5

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM

Installing Memory Modules

1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
IPMI_LAN
USB5/6(3.0)
VGA
LAN2 LAN1
BMC
LAN
CTRL
JPW21 JPW22
PCH
JBT1
USB2/3
1 BT1
X10DRG-O+-CPU
REV: 1.00
BAR CODE 1G/10G MAC CODE
BIOS LICENSE IPMI CODE
10G SAN MAC
JPB1 CLOSE 1st
J1
CPU2
JPME2
JBR1
JWD1
OPEN 1st
JSPK1
JF1
1
JF1
PWR ON RST FAIL PS UID LED 2 NIC NIC 1 LED HDD PWR LED NMI
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
CAUTION
modules to prevent any possible damage.
JPW23 JPW24
JPW5
I-SGPIO2
I-SGPIO1
CLOSE 1st
CPU1
LD1
OPEN 1st
LD2
JPP2
JITP1
JPP1
2-13
Chapter 2: Installation
Notches
Release Tabs