Default Setting - Supermicro X10DAL-i User Manual

Jumper
JBT1
JI C1/JI C2
I2 I2
JPAC1
JPL1
JPL2
JPME2
JPUSB1
JWD1
J21
Connectors
Audio_FP
HD Audio
BT1
COM1
CPU1 Slot1
CPU2 Slot2
CPU1 Slot3/Slot5
PCH Slot6
FAN1-6, FANA
J24
JD1
JF1
JL1
JPI2C1
JPWR1/JPWR2
JSD1/JSD2
JSPDIF_In
JSPDIF_Out
Note: This motherboard supports the latest Thunderbolt technology. For
proper Thunderbolt support, please install the Thunderbolt add-on card on
PCH Slot6 and connect the GPIO cable from the Thunderbolt add-on card
to the GPIO header (JTBT1) on the motherboard for TBT hot-plug support.
X10DAL-i Jumpers
Description
Clear CMOS
SMBus to PCI-E slots
Audio enable
GLAN1 Enable/Disable
GLAN2 Enable/Disable
ME (Manufacture) Mode Select
USB 0/1 Wake-up Enable
Watch Dog
LAN controller EEPROM update
X10DAL-i Connectors
Description
Audio connector for front access
5.1 HD (6-channel High-Definition) + SPDIF audio connector
Onboard CMOS battery (See Chapter 3 for used battery disposal)
Serial port header
PCI-E 3.0 x 8 in 16 slot
PCI-E 3.0 x 4 in 8 slot (This slot is available when CPU2 is installed.)
PCI-E 3.0 x16 slots
PCI-E 2.0 x4 in x8 slot (See the note below for Thunderbolt AOC sup-
port.)
CPU/System fan headers
ATX 24-pin power connector
Speaker/Power LED indicator
Front panel control header
Chassis intrusion header
Power supply SMBbus I
12V 8-Pin power connectors
SATA DOM (Device_On_Module) power connection headers 1/2
SPDIF_(Sony/Philips Digital Interface)_In header
SPDIF_(Sony/Philips Digital Interface)_Out header
1-5
Chapter 1: Overview

Default Setting

See Chapter 2
Pins 2-3 (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Enabled)
Pins 1-2 (Reset)
Open (Disabled)
C header
2