Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X10QRH+ User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
IPMI_LAN
VGA UID
COM1
HEART BEAT LED
SP1
BMC
JBT1
PCH
JSD1 JSD2
J12
T-SGPIO2
X10QRH+
JBAT1
Rev. 1.01
OPEN 1st
OPEN 1st
CPU1
CPU2
JL1
JF1
CLOSE 1st
IPMI CODE
BAR CODE
BIOS
LICENSE
CLOSE 1st
CLOSE 1st
CPU3
CPU4
OPEN 1st
OPEN 1st
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.
CAUTION
modules to prevent any possible damage.
J3
CLOSE 1st
2-11
Chapter 2: Installation
Notches
Release Tabs