Supermicro X10DAi Quick Reference Manual

S
C I
UPERMICR
ontaCt nformatIon
R
• Website: www.supermicro.com
X10Da /X10DaC/X10DaX • General Information: marketing@supermicro.com
I
• Tech Support: support@supermicro.com
Q r g r 1.0a
uICk eferenCe uIDe ev • Phone: +1 (408) 503-8000, Fax: +1 (408) 503-8008

Motherboard Layout and Features

Audio CTRL
LAN CTRL LAN CTRL
FAN4
BIOS
LICENSE
Battery Battery
MAC CODE
BAR CODE
SAS CODE
PCH
JBT1
CLOSE 1st
SAS
CTRL
SAS4~7 SAS0~3
SP1
JSTBY1
JWD1
JS2 FAN2

CPU Installation

Heatsink Installation

Insert and tighten the
screws in the sequence
as shown below.
Socket Keys
Screw#1
Motherboard
CPU Pin1
CPU Keys
Note 1: Graphics shown in this quick reference guide are for illustration only. Your components may or may not look exactly the same as the drawings shown in this
guide.
Note 2: For optimized airflow, please follow your chassis airflow direction to install the correct CPU heatsink direction.
f
or your system to work ProPerly
PrIate DrIvers
• Manuals: http://www.supermicro.com/support/manuals/
• Drivers & Utilities:
• Safety: http://www.supermicro.com/about/policies/safety_information.cfm
USB7/8(3.0) LAN1/2 USB5/6(3.0)
AUDIO_FP
JAUDIO1
USB0/1
CPU2
CLOSE 1st
OPEN 1st
X10DAi/DAC/DAX
Rev. 1.01
CPU1
OPEN 1st
JF1
LE2
FAN6
= mounting hole

Front Panel Control (JF1)

20 19
Ground
NMI
X X
Power LED Vcc
HDD LED Vcc
NIC1 LED Vcc
NIC2 LED Vcc
OH/Fan Fail LED Vcc
Vcc
PWR Fail LED
Screw#2
Ground Reset Reset Button
Screw#3
Power Button
Ground PWR
2 1
, -
Please DownloaD aPPro
/ / ' :
• One (1) Supermicro Motherboard
Images user s manual from the lInks below
• One (1) I/O Shield (MCP-260-00045-1N)
• One (1) Quick Reference Guide (MNL-1563-QRG)
ftp://ftp.supermicro.com/
Jumpers and Connectors

Jumpers

Jumper Description Default Setting
JBT1 Clear CMOS See Chapter 2
JI I2 C1/JI I2 C2 SMBus to PCI-E Slots Pins 2-3 (Normal)
JPL1 GLAN1 & GLAN2 Enable/Disable Pins 1-2 (Enabled)
JPL2 GLAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacture Mode Select Pins 1-2 (ME Mode)
JPS1 (X10DAC Only) SAS Enable Pins 1-2 (Enabled)
JWD1 Watch Dog Pins 1-2 (Reset)

Connectors

Connector Description
Audio_FP (JA1) Audio Connector for Front Access
JAudio1 7.1 HD (8-channel High-Definition) Audio Connector
BT1 Onboard CMOS Battery (See Chapter 3 for Used Battery Disposal)
CPU1 Slot1/Slot3 PCI-E 3.0 x16 Slots (Note: CPU1 has to be installed.)
CPU2 Slot5 PCI-E 3.0 x16 Slot (This slot is available when CPU2 is installed.)
CPU2 Slot2 PCI-E 3.0 x8 Slot (This slot is available when CPU2 is installed.)
CPU2 Slot4 PCI-E 3.0 x8 Slot (The slots are available when CPU2 is installed.)
PCH Slot6 PCI-E 2.0 x4 in x8 Slot
FAN1-7, FANA CPU/System Fan Headers
J24 ATX 24-Pin Power Connector (See Warning on Page 1-6.)
JD1 Speaker/Power LED Indicator
JF1 Front Panel Control Header
JL1 Chassis Intrusion
JPI C1 Power Supply SMBbus I C Header
I2 2
JPWR1/JPWR2 12V 8-Pin Power Connectors (See Warning on Page 1-6.)
JSD1/JSD2 SATA DOM (Device_On_Module) Power Connectors
JSPDIF_In SPDIF_(Sony/Philips Digital Interface)_In Header
JSPDIF_Out SPDIF_(Sony/Philips Digital Interface)_Out Header
JTBT1 GPIO Header for Thunderbolt Add-on Card
JTPM1 TPM (Trusted Platform Module)/Port 80 Header
LAN1/LAN2 G-bit Ethernet Ports 1/2
I-SATA0-9 Serial_Link ATA Connections 0-9 supported by Intel PCH
SAS0-3, 4-7 (JS2) Serial_Link SCSI Connections 0-3, 4-7 supported by LSI SAS Controller
SP1 Onboard Buzzer (Internal Speaker)
STBY1 Standby Power Header
T-SGPIO 1/2/3 Serial-Link General_Purpose IO Headers 1/2/3
USB 5/6 (3.0) Rear USB 3.0 Ports 5/6
USB 7/8 (3.0) Rear USB 3.0 Ports 7/8
USB 9/10 (3.0) Front-accessible USB 3.0 Connections 9/10
USB 0/1 Rear USB 2.0 Connections 0/1
USB 2/3 Front-accessible USB 2.0 Connections 2/3
USB 4 Type A USB 2.0 Connector USB 4

LED Indicators

LED Description State
DS2 (X10DAC Only) SAS Heartbeat LED Green: Blinking
LE2 Standby PWR LED Green: On
Note: Refer to Chapter 1 of the user manual for detailed information on jumpers, connectors,
and LED indicators.
P C
aCkage ontents
• Six (6) SATA Cables (CBL-0044L) (For X10DAi/X10DAX)
• Two (2) SATA Cables (CBL-0044L) (For X10DAC)
• Two (2) SAS Cables (CBL-SAST-0532) (For X10DAC)

CPU Support

Dual Intel ® E5-2600v3/v4 Series Processors (Socket R3-LGA 2011); each processor
supports dual full-width Intel QuickPath Interconnect (QPI) links (of up to 9.6 GT/s one
direction per QPI).

Memory Support

This motherboard supports up to 2048 GB of Registered (RDIMM)/Load Reduced
(LRDIMM) ECC DDR4 2133/1866/1600 MHz memory modules in 16 DIMM slots.
Note: Memory speed support is pending on the CPUs installed on the moth-
erboard. For the latest memory updates, please refer to the Tested Memory
List posted on our website (http://www.supermicro.com/products/motherboard).

Populating DDR4 RDIMM/LRDIMM Memory Modules

Populating RDIMM/LRDIMM DDR4
Memory Modules for the E5-2600v3-
based Motherboard
Speed (MT/s); Voltage
(V);
Slot Per Channel (SPC)
and DIMM Per Channel
(DPC)
Ranks Per DIMM Capacity
(GB)
DIMM and
Type 1 Slot Per
Data 2 Slots Per Channel
Channel
Width
1DPC 1DPC 2DPC
4Gb 8Gb 1.2V 1.2V 1.2V
RDIMM SRx4 8GB 16GB 2133 2133 1866
RDIMM SRx8 4GB 8GB 2133 2133 1866
RDIMM DRx8 8GB 16GB 2133 2133 1866
RDIMM DRx4 16GB 32GB 2133 2133 1866
LRDIMM QRx4 32GB 64GB 2133 2133 2133
LRDIMM
† 8Rx4 64GB 128GB 2133 2133 2133
3DS

Installing DIMM Memory Modules

Back Panel I/O Connectors

4
7 10
3
12
14
2 6 9
11 13
1 5 8
Status
SAS: Normal
SB Power On
Note: Refer to Chapter 2 of the user manual for detailed information on memory support and CPU/motherboard
installation instructions.
Populating RDIMM/LRDIMM DDR4
Memory Modules for the E5-2600v4-
Speed (MT/s)
based Motherboard Voltage (V)
Speed (MT/s); Voltage (V);
Slot Per Channel (SPC) and DIMM Per
Channel (DPC)
DIMM Capacity
Ranks Per
1 Slot Per
(GB)
DIMM and 2 Slots Per Channel
Type Channel
Data
Width
1DPC 1DPC 2DPC
4Gb 8Gb
1.2V 1.2V 1.2V
RDIMM SRx4 8GB 16GB 2400 2400 2133
RDIMM SRx8 4GB 8GB 2400 2400 2133
2400 2400 2133
RDIMM DRx8 8GB 16GB
RDIMM DRx4 16GB 32GB 2400 2400 2133
LRDIMM QRx4 32GB 64GB 2400 2400 2400
LRDIMM
8Rx4 64GB 128GB 2400 2400 2400
3DS
Notches
Release Tabs
1.
Rear USB 3.0 Port 5
2.
Rear USB 3.0 Port 6
3.
Rear USB 2.0 Port 0
4.
Rear USB 2.0 Port 1
5.
SPDIF_Out
6.
Surround_Out
7.
CEN/LFE_Out
8.
Mic_In
9.
Line-Out
10.
Line_In
11.
Gigabit LAN 1
12.
Gigabit LAN 2
13.
Rear USB 3.0 Port 7
14.
Rear USB 3.0 Port 8