Atdc Sensor Automatic Adjustment (F8; (10) 2Nd Mirrors Carriage Distortion Adjustment - Konica Minolta 7115 Service Manual

(9)

ATDC Sensor Automatic Adjustment (F8)

NOTES
• This adjustment is made when the developer has been replaced.
• Make this adjustment with the Toner Bottle removed from the copier.
<Adjustment Procedure>
1. Enter the Function mode.
2. With "F-" shown on the Display, enter the code number "8" from the KEYPAD to set the
copier into the "ATDC Sensor Automatic Adjustment" mode.
3. Press the START.
This automatically runs the "ATDC Sensor Automatic Adjustment" sequence for about
three minutes.
4. After the F8 operation has been completed, check the adjustment value and enter it on
the Adjust Label.

(10) 2nd Mirrors Carriage Distortion Adjustment

1. Remove the ADF Glass.
2. Remove the Original Glass.
3. Move the 2nd Mirrors Carriage toward the adjust-
ment point as shown on the left.
4. Set precision (jeweller's) screwdriver into the
adjusting hole and adjust the 2nd Mirrors Car-
riage Distortion Adjusting Screw.
<Adjustment Instructions>
a<b: Turn the screw clockwise to raise the height.
a>b: Turn the screw counterclockwise to lower the
height.
5. Install the Original Glass and make a copy to
check for images.
6. If there is a problem, repeat step 4.
7. Settle the 2nd Mirrors Carriage Height Adjusting
Screw with the paintlock.
D-61