Counter Mode (Display: - - 3 - Konica Minolta 7115 Service Manual

(4)

Counter Mode (Display: - - 3)

• Shows the number of copies made on each paper size or type.
<Procedure>
1. Enter the code number corresponding to the function to be used from the KEYPAD.
2. Press the START to show the count.
If the count consists of 4 or more digits, it is displayed in two groups alternately as fol-
lows.
E.g.: "123" and "456" alternate if the count is 123,456.
3. Press the PAPER SIZE to select the display of another counter.
4. Call the counter count to be cleared on the Display.
5. Press the CLEAR.
Press INTERRUPT to undo the clearing operation, restoring the original setting.
6. Press the START.
<Exiting the Mode>
• Press the AUTO RESET until the initial screen reappears.
Code No.
Counts the frequency of use of each of the different parts of the
copier.
The count should be cleared when the corresponding PM part is
replaced.
Display Description
--1
1
2
3
4
5
Enter a value for the maintenance counter (for any given part).
The count is based on a countdown system and when the set value is
counted down to "0," the Maintenance Indicator lights.
If counting continues after "0," a minus sign (-) is appended to the
value shown on the Display.
NOTE
• The above counting method varies depending on the setting made
for "c-1" of Tech. Rep. Choice.
--2
The Display shows "nc1" if copying is prohibited.
<Procedure>
1. Press the START to display the current count.
2. Press the CLEAR to clear the current count.
If the current count is mistakenly cleared, press the INTERRUPT
to restore the count just cleared.
3. Enter the new value from the KEYPAD (that can range from 0 to
999999).
4. Press the START to validate the new setting just made.
Setting
<PM Counter>
Display
Bypass Tray 6 5th Tray
1st Tray 7 ADF
2nd Tray 8 IR
3rd Tray 9 Ozone Filter
4th Tray 10 Image Transfer Roller/Fusing Unit
<Maintenance Counter>
S-18
Description