Table of Contents
Advertisement
12.1 VIDEO FEATURES
12.1.1 FLAT PANEL DISPLAY
The onboard flat panel interface provides two connectors which output digital data to drive
panels up to 1024x768 pixels (XGA). The two connectors are described below:
J9
Provides direct connection for 18 and 24 bits TFT and DSTN flat panels
(640x480 and 800x600 display modes).
J1
When used simultaneously with J9, this connector provides direct connection
for 36 bits TFT and DSTN flat panels (1024x768 display mode).
§
Characteristics
Supported display modes are:
640x480 - VGA:
800x600 - SVGA:
1024x768 - XGA:
§
Connection
640x480 and 800x600 flat panel connects directly to J9, using an 18 inches maximum
length flat cable with a 50-pin female header at one end, and an adequate connector,
adapted to the flat panel model at the other end.
1024x768 flat panel requires an additional cable connected to J1. This extra cable must
be 18 inches maximum length, and provide a 26-pin dual-row female header at one
end, and an adequate connector, adapted to connector of the flat panel model at the
other end.
PCI-934 SBC
The PCI-934 board supports many different types of Flat Panel displays. TEKNOR has
fully tested a number of these panels and provides all the BIOS software support and
the technical information needed to properly interface your PCI-934 board with your
selected Flat Panel display.
TFT and DSTN flat panel types at up to 16M colors
TFT and DSTN flat panel types at up to 16M colors
TFT and DSTN flat panel types at up to 64K colors
Standard Connection for VGA and SVGA Display
J20
J1
Extra Connection for XGA Display
12-3
Exploring the Multimedia Capabilities of the Board
VGA
&
SVGA
XGA
Advertisement
Table of Contents
