Table of Contents
Advertisement
9. ETHERNET
The board supports both 10Base-T and 100Base-TX on the same RJ-45 edge bracket
connector. 10Mbps and 100Mbps network speed is automatically detected and switched.
The onboard Ethernet interface may be set for 10Base-T or 100Base-TX operation modes:
The 10Base-T interface uses UTP (Unshielded Twisted Pair) cables, category 5, 4 or 3 (5 is
better), while the 100Base-TX cable must use category 5.
P in #
S ign al
I/O
Transm it D ata +
1
TX +
Transm it D ata -
2
TX -
R eceive D ata +
3
R X +
N ot C o nnecte d
4
N .C .
5
N .C .
N ot C o nnecte d
R eceive D ata -
6
R X -
N ot C o nnecte d
7
N .C .
N ot C o nnecte d
8
N .C .
Ethernet 10Base-T and 100Base-TX
This connection type allows links up to 100m over both shielded twisted pair and data
grade (Cat. 5) unshielded twisted pair or equivalent.
The Ethernet controller resides on the PCI bus and is therefore Plug and Play by default. No
manual configuration is required. A setup program is provided on the driver CD-ROM to
configure the Ethernet controller according to your OS requirements (refer to the OS list on
the CD-ROM – File.txt. The CD-ROM provides several operating system network drivers.
To install the drivers, run the "Setup.exe" program.
For other operating system drivers and installation instructions, contact TEKNOR's
Technical Support department.
G R E EN :
Lin k In tegrity - If th e lin k is g oo d in eith er
10 or 10 0M b ps , the L E D lights O N .
A M B ER :
A ctiv ity - In dica te s eithe r tran sm it o r re ce iv e
ac tivity (ligh ts O N )
9-1
1
8
Advertisement
Table of Contents
