Table of Contents
Advertisement
PCI-934 Technical Reference Manual
3. To connect the daughterdoard to the SBC, line up the J19 connector and the interface
connector, then press firmly the daughterboard into the Single Board Computer's
connector to engage the connector and the spacers.
7.3.2 WORKING WITH A COMPACTFLASH DISK
The CompactFlash module connects directly on the Secondary EIDE interface. It must be
declared the same way as a standard hard disk using the BIOS setup program.
To setup the CompactFlash disk for Master or Slave configuration, use the W11 (1-2)
jumper to select one configuration. To locate and install W11, please refer to Section 11 –
Setting Jumpers.
NOTE
Since data is accessed like it would on an IDE drive, no specific flash
disk driver is requires for various operating systems.
Compact Flash
Daughterboard
Onboard
Compact Flash
Connector
7-4
Advertisement
Table of Contents
