Table of Contents
Advertisement
ERROR INITIALIZING HARD DRIVE DISK CONTROLLER
Cannot initialize controller. Make sure the cord is correctly and firmly installed on
the CPU board. Be sure the correct hard drive type is selected in Setup. Also check to
see if any jumper needs to be set on the hard drive.
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. Make sure the controller is
installed correctly and firmly. If there are no floppy drives installed, be sure the
Diskette Drive selection in Setup is set to NONE.
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no
keys are being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the error halt
condition in Setup to HALT ON ALL, BUT KEYBOARD. This will cause BIOS to
ignore the missing keyboard and continue the boot.
MEMORY ADDRESS ERROR AT ...
Indicates a memory address error at a specific location. You can use this location
along with the memory map for your system to find and replace the bad memory.
MEMORY PARITY ERROR AT ...
Indicates a memory parity error at a specific location. You can use this location along
with the memory map for your system to find and replace the bad memory.
MEMORY VERIFY ERROR AT ...
Indicates an error verifying a value already written to memory. You can use this
location along with the memory map for your system to find and replace the bad
memory.
OFFENDING SEGMENT
This message is used in conjunction with the I/O CHANNEL CHECK and RAM
PARITY ERROR messages when the segment that has caused the problem cannot be
isolated.
E-3
BIOS Setup Error Codes
Advertisement
Table of Contents
