Table of Contents
Advertisement
PCI-934 Technical Reference Manual
F.2
MAKING AN EMERGENCY DISKETTE
Use a system that has a 1.44MB floppy drive A.
1. Insert the TEKNOR EMERGENCY diskette in drive A:
2. Copy the two files WDISK.COM and EMERDISK.TEK from drive A: to your hard
drive (those files are available in your TEKNOR diskette package).
3. Remove the TEKNOR EMERGENCY diskette
4. Format a diskette in drive A:.
5. At the DOS prompt of your hard drive (the same directory as the two files
WDISK.COM and EMERDISK.TEK), type WDISK and then press Enter.
The program may display one of the following messages:
"Emergency Code transferred"
The emergency diskette has been successfully created.
Take the appropriate actions and restart from step 4 when you see the following
messages:
"Write to disk failure!"
Verify if your floppy diskette is write-protected.
"The file to program in flash was not found"
Be sure that EMERDISK.TEK file is in your current directory.
"Unable to read the binary file" or "Unable to close the opened file"
Possible floppy diskette corruption or bad data transfer between floppy disk and host
system.
"Unable to allocate a memory block of 256 Kbytes"
Not enough memory to run the WDISK program.
F-2
Advertisement
Table of Contents
