Preparing Needed Tools
Prepare the tools you need to mount the G350, according to the following table:
Table 1: Mounting Tools
If you need to mount on...
Rack or wall
Flat wall
Uneven wall
You might also need wire cutters to attach the grounding conductors, if your site uses a ground
block.
Choosing the Installation Site
Ensure that the location where you install your G350 fulfills the following requirements:
Cables are away from sources of electrical noise such as:
Radio transmitters
Broadcast amplifiers
Power lines
Fluorescent light fixtures
Water or moisture cannot enter the case of the chassis.
Air can flow freely around all sides of the chassis.
The vents on the sides of the case are not blocked.
Prepare these tools
Phillips head screwdriver
Screws to fasten G350 to the wall
415 x 465 mm (16.5 in. x 18.5 in.) plywood
board 20 mm (7/8 in.) thick
Wood screws
Screws to fasten the G350 to the wall
Preparing Needed Tools
Issue 3 June 2005
11