Preparing Needed Hardware; Laptop; Modem; Preparing Needed Tools - Avaya G250 Quick Start For Hardware Installation

Hide thumbs Also See for G250:

Table of Contents

Before you Start

Preparing Needed Hardware

To configure the Avaya G250 Media Gateway, you need to prepare a laptop with a serial port.

The laptop must have Internet Explorer installed. If you install a G250 without an S8300, you

must prepare the laptop with the following software:

Windows 2000 or Windows XP operating system

●

A TFTP server

●

in order to set up a remote configuration of the G250, you must prepare a USB modem.

Currently, the G250 supports the following modems:

MultiTech USB modem, model MT5634ZBA-USB-V92

●

USRobotics USB modem, model 5637

●

Prepare the tools you need to mount the G250, according to the following table:

Table 1: Mounting Tools

If you need to mount on...

Rack or wall

Flat wall

Uneven wall

You might also need wire cutters to attach the grounding conductors, if your site uses a ground

block.

8 Quick Start for Hardware Installation Avaya G250 Media Gateway

Prepare these tools

Phillips head screwdriver

Screws to fasten G250 to the wall

A 48 in. x 48 in. (1.2 m x 1.2 m) plywood board

(US: 3/4 inch plywood), 0.75 in (20 mm) thick

Screws to fasten the G250 to the wall

Table of Contents