Modem – in order to set up a remote configuration of the G430, you must prepare a USB modem.
●
Currently, the G430 supports the MultiTech USB modem, model MT5634ZBA-USB-V92.
Preparing Tools Needed for Mounting
To mount on a rack or wall, prepare a Phillips head screwdriver.
To mount on a wall prepare also:
415 x 465 mm (16.5 in. x 18.5 in.) plywood board 20 mm (7/8 in.) thick
●
Wood screws
●
Screws to fasten the G430 to the wall
●
You might also need wire cutters to attach the grounding conductors, if your site uses a ground block.
Choosing the Installation Site
Ensure that the location where you install your G430 fulfills the following requirements:
Cables are away from sources of electrical noise such as radio transmitters, broadcast amplifiers,
●
power lines, fluorescent light fixtures
Water or moisture cannot enter the case of the chassis.
●
Air can flow freely around all sides of the chassis.
●
The vents on the sides of the case are not blocked.
●
The installation is no more than 25 feet (7.6 m) from an approved ground.
●
Note:
If the G430 is more than 25 feet (7.6 m) away from an approved ground, you must contact a
Note:
licensed electrician to install a supplementary ground conductor.
The environmental conditions match the following requirements:
●
Ambient temperature – 32
●
Relative humidity – 10-90% relative humidity
●
Minimum clearance for ventilation – 18 in. (45 cm)
●
Weight support – 22.5-35 lbs (10-16 kg)
●
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
o
o
o
o
to 104
F (0
to 40
C)
DRAFT - January 25, 2009 - 1:38 PM
Preparing Tools Needed for Mounting
Issue 1 May 2009
5