Preparing Needed Tools
Prepare the tools you need to mount the G350, according to the following table:
Table 1: Mounting Tools
If you need to mount on...
Rack or wall
Flat wall
Uneven wall
You might also need wire cutters to attach the grounding conductors, if your site uses a ground
block.
Choosing the Installation Site
Ensure that the location where you install your G350 fulfills the following requirements:
Cables are away from sources of electrical noise such as:
●
Radio transmitters
●
Broadcast amplifiers
●
Power lines
●
Fluorescent light fixtures
●
Water or moisture cannot enter the case of the chassis.
●
Air can flow freely around all sides of the chassis.
●
The vents on the sides of the case are not blocked.
●
Prepare these tools
Phillips head screwdriver
Screws to fasten G350 to the wall
415 x 465 mm (16.5 in. x 18.5 in.) plywood
board 20 mm (7/8 in.) thick
Wood screws
Screws to fasten the G350 to the wall
Preparing Needed Tools
Issue 4 February 2006
9