IBM TotalStorage 300 Service Manual page 54

1. After the emergency situation is over or power is restored, check the IBM NAS
2. After you have checked for damage, ensure that the power switches are in the
3. Turn on the power to each device, based on the startup sequence.
4. Turn on both power supply switches on the back of the RAID storage controllers
5. Only the green LEDs on the front and back and the amber Bypass LEDs for
6. Use your installed software application as appropriate to check the status of the
44
IBM NAS 300 Service Guide
300 for damage. If there is no visible damage, continue with Step 2; otherwise,
have your system serviced.
off position; then, plug in the external power cord.
and storage units.
unconnected GBIC ports should remain on. If other amber Fault LEDs are on,
refer to IBM NAS 300 User's Reference for instructions.
IBM NAS 300.