IBM TotalStorage 300 Service Manual page 157

Diags: (Q)uit, (C)ontinue, (S)tats, (L)og: s
Diagnostics Status: Sun Jan 1 00:00:00 2000
port#: 0 1 2 3 4 5 6 7
diags: OK OK OK OK OK OK OK
state: UP UP UP UP UP UP UP UP
lm0: 4654 frTx 4654 frRx 0 LLI_errs.
lm1: 4654 frTx 4654 frRx 0 LLI_errs.
lm2: 4654 frTx 4654 frRx 0 LLI_errs.
lm3: 4654 frTx 4654 frRx 0 LLI_errs.
lm4: 4654 frTx 4654 frRx 0 LLI_errs.
lm5: 4654 frTx 4654 frRx 0 LLI_errs.
lm6: 4654 frTx 4654 frRx 0 LLI_errs.
lm7: 4654 frTx 4654 frRx 0 LLI_errs.
Central Memory OK
Total Diag Frames Tx: 38032
Total Diag Frames Rx: 39232
Table 26. portLoopbackTest field descriptions
Field
Diagnostics status
port#
diags
state
lm0-7 (8-port)
Central memory status
Total diag frames Tx
Total diag frames Rx
Related error messages:
v DIAG=INIT
v DIAG=PORTDIED
v DIAG=XMIT
v DIAG=TIMEOUT
v DIAG=ERRSTAT
v DIAG=STAT
v DIAG=DATA
v DIAG=PORTABSENT
Description
The title header displays the time the
diagShow command was executed.
The port number.
Port's current diagnostic status. Possible
values include OK, BAD.
Port's current state. Possible values include
UP (active), DN (inactive).
The frame counts of active ports. The display
shows the number of frames transmitted and
received and low level interface counts
(LLI_errs).
Central memory status. Possible values
include OK, FAULTY.
The total diagnostics frames transmitted (Tx)
since start up. This number usually
corresponds to the total frames received (Rx)
but may differ because of failure modes.
The total diagnostics frames received (Rx)
since start up. This number usually
corresponds to the total frames transmitted
(Tx) but may differ because of failure modes.
Appendix F. Fibre Channel hub Diagnostics
147