Temperature Checkout - IBM TotalStorage 300 Service Manual

4. Insert the new battery:
5. Reinstall the engine cover and connect the cables.
6. Power-on the engine.
7. Start the Configuration/Setup Utility program and set configuration parameters.

Temperature checkout

Correct cooling of the engine is important for proper operation and reliability. Ensure
that:
v Each of the drive bays has either a drive or a filler panel installed
v Each of the power supply bays has either a power supply or a filler panel
v The top cover is in place during normal operation
v There is at least 50 mm (2 inches) of ventilated space at the sides of the engine
v The top cover is removed for no longer than 30 minutes while the engine is
v The processor housing cover covering the processor and memory area is
v A removed hot-swap drive is replaced within two minutes of removal
v Cables for optional adapters are routed according to the instructions provided
v The fans are operating correctly and the air flow is good
v A failed fan is replaced within 48 hours
In addition, ensure that the environmental specifications for the engine are met.
For more information on specific temperature error messages, see "Temperature
error messages" on page 58.
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the socket.
Note: Wait approximately 20 seconds after you plug the power cord of your
engine into an electrical outlet for the Power Control button to become
active.
v Set the system date and time.
v Set the power-on password.
v Reconfigure your engine.
installed
and 100 mm (4 inches) at the rear of the engine.
operating
removed for no longer that ten minutes while the engine is operating
with the adapters (ensure that cables are not restricting air flow)
Chapter 3. Troubleshooting
29