Loopback-Detection Command; Mac Command; Monitor Command - Planet FGSW-2840 User Manual

6.3.10 loopback-detection Command

Description:
The loopback-detection command is used to enable the loopback detection function globally. To disable it, please use no
loopback detection command
Syntax:
loopback-detection
no loopback-detection
loopback-detection interval interval-time
loopback-detection recovery-time recovery-time

6.3.11 mac Command

Description:
Global MAC configuration subcommands
Syntax:
mac access-list access-list-num
no mac access-list access-list-num
mac address-table aging-time aging-time
no mac address-table aging-time
mac address-table filtering mac mac-addr vid vid
no mac address-table filtering {[ mac mac-addr ] [ vid vid ]}
mac address-table static mac mac-addr vid vid interface { fastEthernet port | gigabitEthernet port }
no mac address-table static { mac mac-addr | vid vid | mac mac-addr vid vid | interface { fastEthernet port | gigabitEthernet
port } }

6.3.12 monitor Command

Description:
Monitoring different system events
Syntax:
monitor session session_num destination interface { fastEthernet port | gigabitEthernet port }
no monitor session session_num
monitor session session_num source interface { fastEthernet port-list | gigabitEthernet port-list } mode
no monitor session session_num source interface { fastEthernet port-list | gigabitEthernet port-list } mode
User's Manual of FGSW-2840 / FGSW-4840S
248