Led Indications - Planet FGSW-2840 User Manual

■ Reset Button
At front panel of Managed Switch, the reset button is designed for reboot the Managed Switch without turn off and on the
power. The following is the summary table of Reset button
Reset Button Pressed and Released
> 5 seconds: Factory Default

2.1.2 LED Indications

The front panel LEDs indicates instant status of port links, data activity, system power and system CPU status; helps monitor
and troubleshoot when needed.
LED Indication
■
FGSW-2840 LED Definition

System
LED Color
PWR Green
SYS Green

10/100Base-TX Interfaces (Port 1 to port 24)
LED
Color
100
Green
LNK/ACT
10
Orange
LNK/ACT
Function
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
。
Figure 2-1-3 & Figure 2-1-4
Figure 2-1-3: FGSW-2840 LED Panel
Lights to indicate that the Switch has power.
Lights and blinking to indicate the CPU is working.
Lights: To indicate the link through that port is successfully established at 100Mbps.
Blink: To indicate that the Switch is actively sending or receiving data over that port.
To indicate the link through that port is successfully established at 10Mbps.
Lights:
To indicate that the Switch is actively sending or receiving data over that port.
Blink:
User's Manual of FGSW-2840 / FGSW-4840S
function:
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
shows the LED indications of the Managed Switch.
Function
Function
18