Command Line Mode - Planet FGSW-2840 User Manual

The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
The CLI is divided into different command modes: User EXEC Mode, Privileged EXEC Mode, Global Configuration Mode,
Interface Configuration Mode and VLAN Database (VLAN Configuration Mode). Interface Configuration Mode can also be
divided into Interface Ethernet, Interface link-aggregation and some other modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode and how to exit the current mode
and access the next mode.
Mode Accessing Path
Primary mode once it is
connected with the Managed
User EXEC
Switch.
Mode
Use the enable command to
enter this mode from User
EXEC mode.
Privileged
EXEC Mode
Use the configure command
to enter this mode from
Privileged EXEC mode.
Global
Configuration
Mode
User's Manual of FGSW-2840 / FGSW-4840S

6. COMMAND LINE MODE

Prompt Logout or Access the next mode
Use the exit command to disconnect the
Managed Switch.
Use the enable command to access
FGSW-4840S>
Privileged EXEC mode.
Use the exit command to disconnect the
Managed Switch.
Enter the disable or the exit command
to return to User EXEC mode.
FGSW-4840S#
Enter configure command to access
Global Configuration mode.
Use the exit or the end command or
press Ctrl+Z to return to Privileged
EXEC mode.
Use the interface type number
FGSW-4840S
command to access interface
(config)#
Configuration mode.
Use the vlan database to access VLAN
Configuration mode.
237