Turbo Mode - Eaglemaster E4 User Manual

- Turbo mode:

If programmed with the feature , this channel will constant output when ignition turn on for over
1 minutes. It will keeps the engine running after arriving at your destination by ignition off for a
programmable of 1, 3, 5, or 10 minutes. This allows the system's timer to conveniently cool down
the turbo after you have left the vehicle.
2-way LCD display :
Note: in turbo mode time , if arming the system, sensors will be bypassed and LED flashing
Green color for a programmed turbo time.
Important: Turbo mode should be used only in open areas. Never start and run the vehicle
in an enclosed space such as a garage or carport.
- CH-5 (-) programme time output:
This channel-5 is a negative (-500mA) output features, this channel can be programmed
(1)- Arming output from 1~120sec.
(2)- Press button
(1)- Arming output 1~120sec. if programmed, this channel will activate when arming, the
output timing can be programmed from 1 to 120seconds.
(2)- Press button
button
Exit: When this channel is outputting, if press button
NOTE: This channel can be programmed pulse delay time (1~120sec.), If programmed,
channel-5 will delay output with programme pulse delay time.
, output from 1~120sec.
output 1~120sec. If programmed, to operate this channel by press
for over 2sec. This channel will constant output for programme time.
Flashing
NOTE:
you may disable this turbo mode
after ignition turn off ,by press
button once, the CH-5 will
stop outputting.
once, it will stop outputting.