Click IP Application > DiffServ in the navigation panel to display the screen as shown.
Figure 150 IP Application > DiffServ
The following table describes the labels in this screen.
Table 117 IP Application > DiffServ
LABEL
Active
Port
*
Active
Apply
Cancel
33.3.1 Configuring 2-Rate 3 Color Marker Settings
Use this screen to configure TRTCM settings. Click the 2-rate 3 Color Marker link in the DiffServ
screen to display the screen as shown next.
XS3900-48F User's Guide
DESCRIPTION
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select Active to enable DiffServ on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 33 Differentiated Services
259