Basic Operation; Turning Power On; Adjusting The Volume; Selecting A Channel - Icom ic-450 Instruction Manual

3

BASIC OPERATION

■ Turning power ON

Hold down
q
If the transceiver is programmed with a start-up
w
password, the screen as described below is displayed.
Enter the password digits using [
➥
To select the digit to edit, push [
➥
When the password is entered, push [
➥
If the "Password" screen does not clear after entering
➥
the digits, the numbers may be incorrect.
10
for 2 seconds to turn the power ON.
] and [].
] and [].
].

■ Adjusting the volume

Push or to adjust the audio level. (0 to 32)
• " " appears when the audio level is set to 0 (silent mode).

■ Selecting a channel

➥ Push [] or [] to select the desired channel.
• Holding down [] or [] continuously changes the displayed
channel until channel 1 is selected.
• When channel 1 is selected, beeps sound.
• "CB CH" is displayed when a CB channel is selected, "Repeater
CH" is displayed when a repeater channel is selected, and
"Receive CH" is displayed when a receive channel is select.