Table of Contents
Advertisement
■ Repeater search scan
The Repeater search scan is used not only to search for
a signal on the repeater channels, but also to access a
repeater by automatically transmitting in sequence. The
Repeater search function detects repeaters that can be
accessed in the area, even if the repeater is not used.
The Repeater search scan detects signals only on the Channels 1
to 8* and 41 to 48. Therefore, the repeater cannot be guaranteed
even though the Repeater scan is stopped, because the scan
will stop if any activity is detected. (The scan is cancelled while
receiving a signal, such as stations communicating in Simplex
operation on a repeater output channel.)
*Does not include the emergency repeater 'RPT05.'
q Select the desired repeater
channel (1 to 8, and 41 to 48),
and then push
to start the
Repeater search scan.
• See the flow to the right for details.
When a signal is received on a repeater channel, the
w
scan stops.
• During the second cycle scanning, 3 high beeps sound when
a signal is received, and 3 low beeps sound when no signal is
received.
Push
to cancel the scan.
e
• While transmitting, the Repeater scan cannot be cancelled.
D Repeater search scan
Blinks
Scan start channel
Searches for signals on the re-
Scan
peater output channels.
Scan start
channel
Automatically accesses the
repeater. (0.5 seconds)
• The TX/RX indicator lights red.
Wait for a signal from the repeater.
(0.5 seconds)
(When no reply signal is received.)
Automatically accesses the next
repeater.
• The TX/RX indicator lights red.
Scan
Scan is automatically cancelled.
NOTE: Excludes the emergency repeater 'RPT05.'
6
SCAN
6
25
Hide quick links:
Advertisement
Table of Contents
