Table of Contents
Advertisement
■ Quiet mode
When the Quiet mode is turned ON, the Selcall mute is
activated and allows Silent operation until receiving a Selcall.
Push
to enter the menu mode.
q
Push [
] or [] to select "Quiet Mode," and then select
w
"On" to turn ON the Quiet mode.
• "Q" appears when the Quiet mode is used.
Appears
To monitor the channel:
➥ Hold down
for 2 seconds to release the mute (audio
is heard).
• The TX/RX indicator blinks when the Monitor function is used.
SELCALL (Selective Calling)
To enable Selcall mute:
While the TX/RX indicator blinks, hold down
seconds to mute the channel.
The TX/RX indicator stops blinking.
NOTE: The Unmute mode may automatically return to
the Mute mode after a specified time period, depending
on the presetting.
■ Stun
If the transceiver is in the Stun mode, it will request a
password when you turn ON the power. This password is
the same as the Power ON function password. Once the
password has been entered, the transceiver will not prompt
to enter it again.
Cloning and transceiver operations are disabled after a kill
ID is received. By activating the clone write mode, you can
use the transceiver again. (The internal data cannot be
accessed using the clone read mode.)
8
for 2
8
31
Hide quick links:
Advertisement
Table of Contents
