Table of Contents
Advertisement
■ SET mode items
D CTCSS/DTCS
Select the desired CTCSS tone frequency or DTCS code.
• The selected CTCSS tone frequency or DTCS code is displayed
on the operating screen when the tone squelch is set to ON or
Pocket Beep is selected.
CTCSS tone frequency
DTCS code mode
mode (default)
D Mic Gain
Set the microphone gain level between 1 (Minimum) and 5
(Maximum).
D Roger Beep
This function transmits a beep to inform that the
transmission is completed.
You can turn the function ON or OFF.
D Beep
This function emits a beep when a key is pushed or held
down. You can turn the function ON or OFF.
D Beep Level
Set the beep output level to High or Low.
D Scan Resume
The Scan Resume can be set as a pause (5sec No Signal) or
timer scan (5sec/10sec/15sec). When signal disappears, scan
resumes after the set period of time. (Default: 5sec No Signal)
• 5sec/10sec/15sec:
Scan pauses for 5, 10, or 15 seconds when a signal is
detected, and then resumes.
• 5sec No Signal:
Scan pauses until the signal disappears, and then resumes
after 5 seconds (Recommended setting).
D Scan Restart
This function starts the scan after transmitting during a scan
after 10 seconds. You can turn the function ON or OFF.
(Default: 3)
• Except for the Repeater search scan.
D Lockout
Select the transmission Lockout (temporary inhibits
(Default: OFF)
transmission) function.
Repeater: You can transmit only while receiving a matched
Busy:
(Default: ON)
OFF:
(Default: High)
CTCSS tone, or receiving no signal.
Transmission is inhibited while receiving a signal.
No restriction for receiving a signal.
4
SET MODE
4
(Default: OFF)
(Default: OFF)
17
Hide quick links:
Advertisement
Table of Contents
