Installing Upper Rewind Housings; Additional Installation Items - Gfp 255 C Operating Manual

10. Install upper rewind housings
1. Remove left and right upper rewind housing from accessory box
2. Bolt right upper rewind housing with tension adjustment knobs to
inside the right side frame of machine using (3) Hex 5mm x 12 screws
and lock washers ( Star washer used where paint is removed)
3. Bolt left upper rewind housing to inside the left side frame of machine
using (3) Hex 5mm x 12 screws and lock washers
(Note: Both housings angle toward front of the machine)
4. Slide upper supply/rewind brakes onto two (2) hex rewind shafts
(See section 12 for the direction of the core clips)
5. Insert slotted end of each upper Rewind shaft into the right shaft
housing with tension adjustment and drop in place on the left housing
Left rewind housing
1. Top Liner rewind shaft 2. Supply shaft 3. Tension adjustment knobs

11. Additional Installation items

1. Plug foot pedal into rear panel near power cord
2. Check drive chains for tightness
3. Check all drive set screws for tightness
4. Check all electrical connections and input power and test for proper operation
Gfp 255 C
Right rewind housing
1
2
15
June 2012
3