Operation; Roller Gap - Gfp 255 C Operating Manual

16. Operation

1. Plug power cord into a proper receptacle
Connect the attachment plug provided with the laminator to a suitably
•
grounded outlet only. This machine must have reliable earth wire to ensure
the safety of the machine during operations
• Contact an electrician should the attachment plug provided with the laminator
not match the receptacles at your location
• Ensure that the voltages of the power supply you are using match the rated
working voltages before operations. Do not use incorrect power supply
• Do not use damaged wires or sockets. If abnormal conditions occur, switch
off the power supply first.
2. Turn power to "ON" with the rear power switch

17. Roller Gap

1. When the pressure-adjusting hand-wheel is turned clockwise, the top rubber
roller comes down and the pressure will increase
2. With a counter-clock turn, the top rubber roller goes up and the pressure will
decrease.
3. Too much nip pressure will wrinkle the output. Bring the nip roller down to
just touch the image, then a slight increase in pressure
4. When using the 255C, bring the rollers down only to touch the two webs
together.
Gfp 255 C
20
June 2012