Loading Bottom Supply Roll - Gfp 255 C Operating Manual

13. Loading Bottom Supply roll

1. Loosen the fastening screws on the brake assembly on one side of the round
supply shaft, and slide brake assembly off the supply shaft.
2. Slide the new roll onto the supply shaft
3. Return the brake assembly to the supply shaft
4. Position the supply roll in the middle of the supply shaft and measure the
distance from one side of the roll to the side frame
measurement when loading the top supply roll in section #14 to align the top
and bottom rolls)
5. Fasten the screws for brake assembly (Note: there should be 1/8" clearance
between the positioning and the adjusting sleeves of the film core adaptor to
make brake adjustment easier),
6. Adjust the brake tension by turning the adjusting sleeve
(Note: the brake tension should not prevent roll from turning)
1. Supply shaft 2. Substrate 3. Cardboard core 4. Positioning sleeve
5. Brake adjustment screw 6.Fastening screws for the brake assembly 7. Brake assembly
Gfp 255 C
17
June 2012
( You'll use this