Quick Start - Mitsubishi DPLUS 74SB -BKA Service Manual

Quick Start

To attach the Diamond Plus monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the Diamond Plus Macintosh cable adapter (not in-
cluded) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the Diamond Plus
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the Diamond Plus 74
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.
4. For download information on the Windows
for your Diamond Plus monitor, refer to the References section of this User's
Manual.
5. Connect one end of the power cord to the Dimond Plus monitor and the other
end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
Figure A.1
15-pin
mini
D-SUB
Captive Signal Cable
Macintosh cable adapter, call
SB
95/98/Me/2000/XP INF file
®
Figure B.1
Captive Signal Cable
3
1-5
Mac Adapter
(Not Included)