Quick Start - Mitsubishi E55LCD Service Manual

Contents
Your new LCD monitor box* should contain the following:
• LCD Monitor with tilt base
• Power cord
• Video Signal Cable (D-SUB to D-SUB Cable)
• User's Manual
User's Manual
* Remember to save your original box and packing material to transport or ship the monitor.

Quick Start

To attach the LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC with Analog output: Connect the 15-pin mini D-SUB to D-SUB signal cable to the connector of the display
card in your system (Figure A.1).
For the Mac: Connect the Macintosh cable adapter (not included) to the computer (Figure B.1).
Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
Figure A.1
3. Remove connector cover. Connect the D-SUB signal cable to the connector on the back of the monitor. Place the video
signal cable (Figure C.1). Replace connector cover.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module
and/or shorten the module's life.
4. Remove connector cover. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end
to the power outlet (Figure D.1). Replace the power cord cover.
5. Press an arrow point " " portion with take off connector cover.
NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.
Power Cord
Video Signal Cable
(D-SUB to D-SUB Cable)
Mac Adapter
(not included)
English-2
1-7
Macintosh G3 and G4
do not require an
adapter
Figure B.1