Quick Start - Mitsubishi DiamondPoint NXM76LCD User Manual

Quick Start

To attach the DiamondPoint LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. Connect the audio cable to "AUDIO INPUT" on the back of the monitor and the other
end to the "Audio out" terminal of the computer (Figure A.1).
3. Remove cable cover. For the PC or MAC with DVI digital output: Connect the DVI
signal cable (not included) to the connector of the display card in your system (Figure
B.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure B.2). Tighten all screws.
For the MAC: Connect the DiamondPoint Macintosh cable adapter to the computer,
then attach the 15-pin mini D-SUB signal cable to the DiamondPoint Macintosh cable
adapter (Figure C.1). Tighten all screws.
NOTE: To obtain the DiamondPoint Macintosh cable adapter, call NEC-Mitsubishi
Electronics Display of America, Inc. at (800) 632-4662.
4. Connect the 15-pin mini D-SUB of the video signal cable and DVI signal cable (not
included) to the appropriate connector on the back of the monitor (Figure D.1).
5. Connect one end of the power cord to the DiamondPoint LCD Series monitor and the
other end to the power outlet. Place the Audio Cable, Video Signal Cable and power
cord under Cable cover (Figure D.1). Replace cable cover.
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
6. Headphones may be connected to the "Headphones" output on the front of the
monitor's bezel marked "
sound from the speakers will be disabled. Headphones can be purchased from your
local electronics store.
NOTE: Adjust position of cable that place under cable cover, to avoid damage for cable
or monitor.
7. The vacation switch on the right side of the monitor must be turned on (Figure F.1).
Turn on the monitor with the front power button and the computer.
NOTE: The vacation switch is a true on/off switch. If this switch is on the OFF position,
the monitor cannot be turned on using the front button. DO NOT switch on/off
repeatedly.
8. Analog input only. No-touch Auto Adjust automatically adjusts the monitor to optimal
settings upon initial setup for most timings. For further adjustments, use the following
OSD controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User 's Manual for a full description of these
OSD controls.
NOTE: For download information on the Windows
DiamondPoint monitor, refer to the References section of this User's Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
NXMLCD122702.p65
" (Figure E.1). While the headphones are connected, the
® 95/98/Me/2000/XP INF file for your
3
3 12/27/02, 3:32 PM