Inspection Of Plug & Play Communication And Osm "Monitor Information" For Model Name/ Serial Number; A System Construction; Input Signal; Programs Required - Mitsubishi DPLUS 74SB -BKA Service Manual

7. Inspection of PLUG & PLAY Communication and OSM "MONITOR INFORMATION" for
Model Name/ Serial Number

7.1 A System Construction

This system should be connected as shown below.
Program Disk
Part No. 599910529
DESKTOP/NOTE
Signal Generator

7.2 Input Signal

Horizontal sync frequency: Not specified.
Vertical sync frequency: Not specified.

7.3 Programs Required

CN8701.EXE
DP74SB.BAT
DP74SB.TXT

7.4 Inspection Procedures

a. Power on pressing "-" button.
b. Copy the above-mentioned programs in an adequate directory.
c. Set up the MO-DOS mode. (DOS Prompt of Windows95/98 is also acceptable.)
d. Execute the DP74SB.BAT from the command line.
e. "MONITOR INFO." of the OSM is indicated, and a model name and a serial number are confirmed.
When the model name and the serial number are not written in or it differs, h or later is performed.
f. Press the F1 key to start the inspection of DDC1.
As a result of inspection, when EDID data is not written in or it differs, h or later is performed.
g. Press the F2 key to start the inspection of DDC2B.
As a result of inspection, when EDID data is not written in or it differs, h or later is performed..
h. Check the serial number of the set and enter an input of the following code from the keyboard.
*08109691 Serial Number* (*+Model Code + 3 Spaces + Serial No. +*)
Example: *08109693...2150001YB*
Printer Cable
PC
Signal Cable
Part No.599910508
Signal Cable
EDID JIG
(NPG)
5-27
Monitor