Mitsubishi DPLUS 74SB -BKA Service Manual page 107

3. Power saving – 2 pins (PMUS, PMUO) for power saving control
– if Hf > 70kHz or Hf < 23kHz, enter power saving mode (suspend).
– enter power saving mode after 3 sec when condition is met.
– enter suspend mode first for 3 sec before enter off mode if off mode condition is met.
Mode
Normal
Stand By
Suspend
Off
Burn-in
4. Mute – 2 pins for screen mute
Mute1 – active low pulse for about 0.6 sec when mode change.
Mute2 – active low pulse for about 1.0 sec when mode change, active with mute 1 simultaneously.
5. D/A – 14 pins (PWM output) are Brightness, Contrast, H-phase, H-size, V-center, V-size,
Pincushion, Trapezoid, Rotation, Parallel, Pin-balance, R-gain, G-gain and B-gain.
– DAC value 255 means the maximum output volts except Parallel PWM.
– All D/A except Rotation, Brightness, Contrast, R-gain G-gain B-gain are mode dependent
functions.
– Parallel is voltage inverter function.
6. Sync output – 2 pins for H-sync and V-sync negative output, normal high.
7. DDC – 2 pins (DDC SDA/DDC SCL) for DDC1/DDC2B or auto alignment control.
– In auto alignment mode, all keys and OSD are disabled.
8. SDA/SCL – 2 pins for EEPROM and OSD control.
9. WP – 1 pin, high for EEPROM write protect.
Control Panel Operation
KEY
KEY name
EXIT
1. Key arrangement – 7 keys for OSD control.
2. Hot key operation
Factory Mode: SELECT Key + UP (+) Key if pressed when the power SW on.
H-sync freq. V-sync freq. Burn-in ID
Yes Yes
No Yes
Yes No
No No
No No
< >
PMUS
--- 1
--- 0
--- 0
Low 0
High 1
+ - SELECT RESET
7-6
PMUO
1
1
1
0
1