Table of Contents
Advertisement
Connection Log
Connection Log
Buttons
Connect
Disconnect
Clear Log
Refresh
Connection Details - SingTel RAS
If using the SingTel RAS access method, a screen like the following example will be displayed
when the "Connection Details" button is clicked.
Data - RAS
Internet
RAS Plan
Physical Address
IP Address
nect buttons unless the setting "Connect automatically, as re-
quired" is disabled.
•
The Connection Log shows status messages relating to the
existing connection.
•
The Clear Log button will restart the Log, while the Refresh
button will update the messages shown on screen.
If not connected, establish a connection to Telstra Big Pond.
If connected to Telstra Big Pond, terminate the connection.
Delete all data currently in the Log. This will make it easier to read
new messages.
Update the data on screen.
Figure 29: Connection Details - RAS
The RAS Plan which is currently used.
The hardware address of this device, as seen by remote devices on
the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
The IP Address of this device, as seen by Internet users. This address
is allocated by your ISP (Internet Service Provider).
Operation and Status
43
Advertisement
Table of Contents
