F a n l e s s P a n e l P C s
Jumpers and Connectors
Setting jumpers
You can configure your panel pc to match the needs of your application by
setting jumpers. A jumper is the simplest kind of electric switch. It consists
of two metal pins and a small metal clip (often protected by a plastic cover)
that slides over the pins to connect them.
To "close" a jumper you connect the pins with the clip. To "open" a
jumper you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2
and 3.
The jumper settings are schematically depicted in this manual as follows:.
Open
A pair of needle-nose pliers may be helpful when working with jumpers.
If you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before you
make any changes.
Generally, you simply need a standard cable to make most connections
PC-3200 Series User Manual V1.2
Open
Open
P C - 3 2 0 0
Closed
Closed
Closed
3
1 2
Closed 2-3
Closed 2-3
Closed 2-3
36