Introduction; Installing The 2.5" Hard Disk Drive (Hdd) - Aaeon PC-3200 User Manual

F a n l e s s P a n e l P C s

Introduction

The panel PC consists of a PC-based computer that is housed in a plastic rear
panel and a metal shielding case. You can install HDD, SDRAM and battery
pack by removing the rear panel and shielding case. Any maintenance or
hardware upgrades can be easily completed after removing the rear panel and
shielding case.
If you are a systems integrator and need to know how to completely
disassemble the panel PC, you can find more useful information in Appendix C.
Warning!

Installing the 2.5" Hard Disk Drive (HDD)

You can attach one enhanced Integrated Device Electronics (IDE) hard disk drive
to the panel PC's internal controller which uses a PCI local-bus interface. The
advanced IDE controller supports faster data transfer and allows the IDE hard
drive to exceed 528 MB. The following are instructions for installation:
PC-3200 Series User Manual V1.2
Do not remove the plastic rear cover until you have
verified that no power is flowing within the panel PC.
Power must be switched off and the power cord must
be unplugged. Every time you service the panel PC,
you should be aware of this.
P C - 3 2 0 0
28